Adding iPads to Apple Business Manager and Enrolling in RMM
Purpose and Scope
This article describes how to add a new iPad to Apple Business Manager (ABM) and enroll it in the N-able RMM so it receives the Northway management profile automatically. The process requires two erases of the iPad and takes place in five parts: adding the device with Apple Configurator, reassigning it to the N-able MDM server in ABM, creating the mobile device entry in RMM, installing the Northway profile, and cleaning up the RMM entries.
This article is intended for IT Department staff responsible for deploying and enrolling company-owned iPads.
Prerequisites
Have the following ready before starting:
- An iPad already enrolled and signed in as the Configurator iPad (running Apple Configurator)
- The new iPad, powered off, still in its factory state
- Administrator access to the Apple Business Manager website
- Administrator access to the N-able RMM console
- Access to the IT Department mailbox (ITdept@northway.org) and to outlook.office.com
- A stable Wi-Fi network for the new iPad
Part 1: Add the iPad to Apple Business Manager
Use the Configurator iPad to add the new device to ABM by proximity pairing.
- Sign in on the Configurator iPad.
- Power on the new iPad and go to the Wi-Fi selection screen. Do not go any further than this screen. If you do, the iPad must be restarted and the process begun again.
- Hold the two devices close together until an indicator appears on the new iPad prompting you to scan it with the Configurator iPad.
- Scan the new iPad with the Configurator iPad.
- Once the device has been added, Apple Configurator will require you to erase the new iPad. Do not erase it yet. Complete Part 2 first.
Part 2: Reassign the Device in Apple Business Manager
With the erase prompt still pending on the new iPad, assign the device to the N-able MDM server.
- Log in to the Apple Business Manager website.
- Search for the new device.
- Click Assigned Device Management so the device can be reassigned.
- Assign the device to N-able 2025.
Part 3: Erase the iPad and Add It in RMM
The RMM entry is created while the iPad is erasing, so the two tasks overlap.
- On the New iPad, Complete the erase.
- While the iPad is erasing, log in to the RMM.
- Select the Mobile Devices tab, then click Add Mobile Device.
- Complete the pop-up form using ITdept@northway.org.
- When the new iPad has finished erasing and restarted, set it up as normal.
Part 4: Install the Northway Profile and Re-Enroll
The first setup is used only to install the Northway profile. A second erase and setup allows the iPad to enroll automatically.
- After the iPad is set up, open a browser and go to outlook.office.com.
- Sign in and install the Northway profile.
- Once the profile is installed, erase the iPad one more time.
- Set the iPad up as normal again.
Part 5: Clean Up RMM and Verify
After the second setup, the iPad creates a new RMM entry that shows only its serial number and installs the Northway profile automatically.
- In RMM, locate the new entry that is listed by serial number only.
- Delete the original entry that was created manually in Part 3.
- Rename the serial-number-only entry so that it reflects the new iPad.
- Open the device details and confirm that every item under Supported Features shows a check mark.
Notes
- Stop at the Wi-Fi selection screen in Part 1. Going further requires restarting the iPad and starting over.
- Do not erase the iPad until the device has been reassigned to N-able 2025 in ABM (Part 2).
- The iPad is erased twice in total: once after it is added in Configurator, and once after the Northway profile is installed.
- If any Supported Features check is missing in Part 5, the device is not fully enrolled. Review the RMM device details before handing the iPad to the user.